OpenBSD-4.6/etc/sensorsd.conf

# $OpenBSD: sensorsd.conf,v 1.8 2007/08/14 19:02:02 cnst Exp $

#
# Sample sensorsd.conf file. See sensorsd.conf(5) for details.
#

# +5 voltage (volts)
#hw.sensors.lm0.volt3:low=4.8V:high=5.2V

# +12 voltage (volts)
#hw.sensors.lm0.volt4:low=11.5V:high=12.5V

# Chipset temperature (degrees Celsius)
#hw.sensors.lm0.temp0:high=50C

# CPU temperature (degrees Celsius)
#hw.sensors.lm0.temp1:high=60C

# CPU fan (RPM)
#hw.sensors.lm0.fan1:low=3000

# ignore certain indicators on ipmi(4)
#hw.sensors.ipmi0.indicator1:istatus

# Warn if any temperature sensor is over 70 degC.
# This entry will match only those temperature sensors
# that don't have their own entry.
#temp:high=70C


# By default, sensorsd(8) reports status changes of all sensors that 
# keep their state. Uncomment the following lines if you want to 
# suppress reports about status changes of specific sensor types.

#temp:istatus
#fan:istatus
#volt:istatus
#acvolt:istatus
#resistance:istatus
#power:istatus
#current:istatus
#watthour:istatus
#amphour:istatus
#indicator:istatus
#raw:istatus
#percentage:istatus
#illuminance:istatus
#drive:istatus
#timedelta:istatus