2.11BSD/man/cat4/css.0

CSS(4)		    UNIX Programmer's Manual		   CSS(4)



NAME
     css - DEC IMP-11A LH/DH IMP interface

SYNOPSIS
     /sys/conf/SYSTEM:
	  NCSS _c_s_s__c_o_n_t_r_o_l_l_e_r_s	   # DEC/CSS IMP11-A ARPAnet IMP interface

DESCRIPTION
     The _c_s_s device provides a Local Host/Distant Host interface
     to an IMP.  It is normally used when participating in the
     DARPA Internet.  The controller itself is not accessible to
     users, but instead provides the hardware support to the IMP
     interface described in _i_m_p(4).  When configuring, the
     _i_m_p(_N_I_M_P) pseudo-device is also included.

DIAGNOSTICS
     css%d: not alive.	The initialization routine was entered
     even though the device did not autoconfigure.  This is indi-
     cates a system problem.

     css%d: can't initialize.  Insufficient UNIBUS resources
     existed to initialize the device.	This is likely to occur
     when the device is run on a buffered data path on an 11/750
     and other network interfaces are also configured to use buf-
     fered data paths, or when it is configured to use buffered
     data paths on an 11/730 (which has none).

     css%d: imp doesn't respond, icsr=%b.  The driver attempted
     to initialize the device, but the IMP failed to respond
     after 500 tries.  Check the cabling.

     css%d: stray output interrupt csr=%b.  An interrupt occurred
     when no output had previously been started.

     css%d: output error, ocsr=%b icsr=%b.  The device indicated
     a problem sending data on output.

     css%d: recv error, csr=%b.  The device indicated a problem
     receiving data on input.

     css%d: bad length=%d.  An input operation resulted in a data
     transfer of less than 0 or more than 1008 bytes of data into
     memory (according to the word count register).  This should
     never happen as the maximum size of a host-IMP message is
     1008 bytes.










Printed 11/26/99	 August 20, 1987			1