NetBSD-5.0.2/sys/arch/mipsco/conf/stand.ldscript

/*	$NetBSD: stand.ldscript,v 1.4 2005/12/11 12:18:13 christos Exp $	*/

/*  ldscript for NetBSD/mipsco standalone bootstraps */
OUTPUT_FORMAT("elf32-tradbigmips", "elf32-tradbigmips", "elf32-tradlittlemips")
OUTPUT_ARCH(mips)
ENTRY(_start)
SECTIONS
{
  /*  Read-only sections, merged into text segment.  Assumes the
      kernel Makefile sets the start address via -Ttext.  */
  .text      :
  {
    _ftext = . ;
    *(.text)
    *(.gnu.warning)
  } =0
  _etext = .;
  PROVIDE (etext = .);
  .rodata    : { *(.rodata)  }
  .data    :
  {
    _fdata = . ;
    *(.data)
    CONSTRUCTORS
  }
  _gp = ALIGN(16);
  .lit8 : { *(.lit8) }
  .lit4 : { *(.lit4) }
  .sdata     : { *(.sdata) }
  _edata  =  .;
  PROVIDE (edata = .);
  __bss_start = .;
  _fbss = .;
  .bss       :
  {
   *(.bss)
   *(COMMON)
   *(.sbss)
   *(.scommon)
  }
  _end = . ;
  PROVIDE (end = .);

  /*
   * Depending on the nuber of sections and their relative position
   * the Mips PROM firmware incorrectly loads the image into memory
   * 8 bytes higher than expected.  If this happens change the following
   * definition from .reginfo to /DISCARD/ to remove the section
   */

  .reginfo : { *(.reginfo) }
}