NetBSD-5.0.2/sys/dev/eisa/ahbreg.h
/* $NetBSD: ahbreg.h,v 1.16 2008/04/28 20:23:48 martin Exp $ */
/*-
* Copyright (c) 1997, 1998 The NetBSD Foundation, Inc.
* All rights reserved.
*
* This code is derived from software contributed to The NetBSD Foundation
* by Charles M. Hannum and by Jason R. Thorpe of the Numerical Aerospace
* Simulation Facility, NASA Ames Research Center.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
* TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
* PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
* BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
* CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
* CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGE.
*/
/*
* Originally written by Julian Elischer (julian@tfs.com)
* for TRW Financial Systems for use under the MACH(2.5) operating system.
*
* TRW Financial Systems, in accordance with their agreement with Carnegie
* Mellon University, makes this software available to CMU to distribute
* or use in any manner that they see fit as long as this message is kept with
* the software. For this reason TFS also grants any other persons or
* organisations permission to use or modify this software.
*
* TFS supplies this software to be publicly redistributed
* on the understanding that TFS is not responsible for the correct
* functioning of this software in any circumstances.
*/
typedef u_int32_t physaddr;
typedef u_int32_t physlen;
/*
* Offset of AHA1740 registers, relative from slot base.
*/
#define AHB_EISA_SLOT_OFFSET 0x0c80
#define AHB_EISA_IOSIZE 0x0080
/*
* AHA1740 EISA board mode registers (relative to port offset)
*/
#define PORTADDR 0x40
#define PORTADDR_ENHANCED 0x80
#define BIOSADDR 0x41
#define INTDEF 0x42
#define SCSIDEF 0x43
#define BUSDEF 0x44
/**** bit definitions for INTDEF ****/
#define INT9 0x00
#define INT10 0x01
#define INT11 0x02
#define INT12 0x03
#define INT14 0x05
#define INT15 0x06
#define INTHIGH 0x08 /* int high=ACTIVE (else edge) */
#define INTEN 0x10
/**** bit definitions for SCSIDEF ****/
#define HSCSIID 0x0F /* our SCSI ID */
#define RSTPWR 0x10 /* reset scsi bus on power up or reset */
/**** bit definitions for BUSDEF ****/
#define B0uS 0x00 /* give up bus immediatly */
#define B4uS 0x01 /* delay 4uSec. */
#define B8uS 0x02
/*
* AHA1740 ENHANCED mode mailbox control regs (relative to port offset)
*/
#define MBOXOUT0 0x50
#define MBOXOUT1 0x51
#define MBOXOUT2 0x52
#define MBOXOUT3 0x53
#define ATTN 0x54
#define G2CNTRL 0x55
#define G2INTST 0x56
#define G2STAT 0x57
#define MBOXIN0 0x58
#define MBOXIN1 0x59
#define MBOXIN2 0x5A
#define MBOXIN3 0x5B
#define G2STAT2 0x5C
/*
* Bit definitions for the 5 control/status registers
*/
#define ATTN_TARGET 0x0F
#define ATTN_OPCODE 0xF0
#define OP_IMMED 0x10
#define AHB_TARG_RESET 0x80
#define OP_START_ECB 0x40
#define OP_ABORT_ECB 0x50
#define G2CNTRL_SET_HOST_READY 0x20
#define G2CNTRL_CLEAR_EISA_INT 0x40
#define G2CNTRL_HARD_RESET 0x80
#define G2INTST_TARGET 0x0F
#define G2INTST_INT_STAT 0xF0
#define AHB_ECB_OK 0x10
#define AHB_ECB_RECOVERED 0x50
#define AHB_HW_ERR 0x70
#define AHB_IMMED_OK 0xA0
#define AHB_ECB_ERR 0xC0
#define AHB_ASN 0xD0 /* for target mode */
#define AHB_IMMED_ERR 0xE0
#define G2STAT_BUSY 0x01
#define G2STAT_INT_PEND 0x02
#define G2STAT_MBOX_EMPTY 0x04
#define G2STAT2_HOST_READY 0x01
#define AHB_NSEG 33 /* number of DMA segments supported */
struct ahb_dma_seg {
physaddr seg_addr;
physlen seg_len;
};
struct ahb_ecb_status {
u_short status;
#define ST_DON 0x0001
#define ST_DU 0x0002
#define ST_QF 0x0008
#define ST_SC 0x0010
#define ST_DO 0x0020
#define ST_CH 0x0040
#define ST_INT 0x0080
#define ST_ASA 0x0100
#define ST_SNS 0x0200
#define ST_INI 0x0800
#define ST_ME 0x1000
#define ST_ECA 0x4000
u_char host_stat;
#define HS_OK 0x00
#define HS_CMD_ABORTED_HOST 0x04
#define HS_CMD_ABORTED_ADAPTER 0x05
#define HS_TIMED_OUT 0x11
#define HS_HARDWARE_ERR 0x20
#define HS_SCSI_RESET_ADAPTER 0x22
#define HS_SCSI_RESET_INCOMING 0x23
u_char target_stat;
u_int32_t resid_count;
u_int32_t resid_addr;
u_short addit_status;
u_char sense_len;
u_char unused[9];
u_char cdb[6];
};
struct ahb_ecb {
u_char opcode;
#define ECB_SCSI_OP 0x01
u_char:4;
u_char options:3;
u_char:1;
short opt1;
#define ECB_CNE 0x0001
#define ECB_DI 0x0080
#define ECB_SES 0x0400
#define ECB_S_G 0x1000
#define ECB_DSB 0x4000
#define ECB_ARS 0x8000
short opt2;
#define ECB_LUN 0x0007
#define ECB_TAG 0x0008
#define ECB_TT 0x0030
#define ECB_ND 0x0040
#define ECB_DAT 0x0100
#define ECB_DIR 0x0200
#define ECB_ST 0x0400
#define ECB_CHK 0x0800
#define ECB_REC 0x4000
#define ECB_NRB 0x8000
u_short unused1;
physaddr data_addr;
physlen data_length;
physaddr status;
physaddr link_addr;
short unused2;
short unused3;
physaddr sense_ptr;
u_char req_sense_length;
u_char scsi_cmd_length;
short cksum;
u_char scsi_cmd[12];
/*-----------------end of hardware supported fields----------------*/
struct ahb_dma_seg ahb_dma[AHB_NSEG];
struct ahb_ecb_status ecb_status;
struct scsi_sense_data ecb_sense;
TAILQ_ENTRY(ahb_ecb) chain;
struct ahb_ecb *nexthash;
int32_t hashkey;
struct scsipi_xfer *xs; /* the scsipi_xfer for this cmd */
int flags;
#define ECB_ALLOC 0x01
#define ECB_ABORT 0x02
#define ECB_IMMED 0x04
#define ECB_IMMED_FAIL 0x08
int timeout;
/*
* This DMA map maps the buffer involved in the transfer.
* Its contents are loaded into "ahb_dma" above.
*/
bus_dmamap_t dmamap_xfer;
};