OpenBSD-4.6/share/misc/scsi_modes
# $OpenBSD: scsi_modes,v 1.4 2007/12/09 21:26:19 dlg Exp $
# SCSI mode page data base.
# Copyright (c) 1995 HD Associates
# (contact: dufault@hda.com)
# All rights reserved.
#
# Redistribution and use in source and binary forms, with or without
# modification, are permitted provided that the following conditions
# are met:
# 1. Redistributions of source code must retain the above copyright
# notice, this list of conditions and the following disclaimer.
# 2. Redistributions in binary form must reproduce the above copyright
# notice, this list of conditions and the following disclaimer in the
# documentation and/or other materials provided with the distribution.
# 3. The name of HD Associates
# may not be used to endorse or promote products derived from this software
# without specific prior written permission.
#
# THIS SOFTWARE IS PROVIDED BY HD ASSOCIATES ``AS IS'' AND
# ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
# IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
# ARE DISCLAIMED. IN NO EVENT SHALL HD ASSOCIATES BE LIABLE
# FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
# DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
# OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
# HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
# LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
# OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
# SUCH DAMAGE.
# The ordering is alphabetical by page name, as it appears in the SCSI spec.
# ALL DEVICE TYPES
# Control mode page:
0x0a {
{Reserved} *t7
{RLEC} t1
{Queue Algorithm Modifier} t4
{Reserved} *t2
{QErr} t1
{DQue} t1
{EECA} t1
{Reserved} *t4
{RAENP} t1
{UAAENP} t1
{EAENP} t1
{Reserved} *i1
{Ready AEN Holdoff Period} i2
}
# Disconnect-Reconnect Page:
0x02 {
{Buffer Full Ratio} i1
{Buffer Empty Ratio} i1
{Bus Inactivity Limit} i2
{Disconnect Time Limit} i2
{Connect Time Limit} i2
{Maximum Burst Size} i2
{Reserved} *t6
{DTDC} t2
{Reserved} *i1
{Reserved} *i1
{Reserved} *i1
}
# Peripheral Device Page:
0x09 {
{Interface Identifier} i2
{Reserved} *i1
{Reserved} *i1
{Reserved} *i1
{Reserved} *i1
}
# DIRECT ACCESS DEVICES
# Caching page:
0x08 {
{IC} t1
{ABPF} t1
{CAP} t1
{DISC} t1
{SIZE} t1
{WCE} t1
{MF} t1
{RCD} t1
{Demand Retention Priority} t4
{Write Retention Priority} t4
{Disable Pre-fetch Transfer Length} i2
{Minimum Pre-fetch} i2
{Maximum Pre-fetch} i2
{Maximum Pre-fetch Ceiling} i2
{FSW} t1
{LBCSS} t1
{DRA} t1
{Vendor-specific} t2
{Reserved} *t2
{NV_DIS} t1
{Number of Cache Segments} i1
{Cache Segment Size} i2
{Reserved} *i1
{Obsolete} *i2
}
# Flexible disk page:
0x05 {
{Transfer rate} i2
{Number of heads} i1
{Sectors per track} i1
{Data bytes per sector} i2
{Number of cylinders} i2
{Starting cylinder-write precompensation} i2
{Starting cylinder-reduced write current} i2
{Drive step rate} i2
{Drive step pulse width} i1
{Head settle delay} i2
{Motor on delay} i1
{Motor off delay} i1
{TRDY} t1
{SSN} t1
{MO} t1
{Reserved} *t5
{Reserved} *t4
{SPC} t4
{Write Compensation} i1
{Head load delay} i1
{Head unload delay} i1
{Pin 34} t4
{Pin 2} t4
{Pin 4} t4
{Pin 1} t4
{Medium rotation rate} i2
{Reserved} *i1
{Reserved} *i1
}
# Format device page:
0x03 {
{Tracks per Zone} i2
{Alternate Sectors per Zone} i2
{Alternate Tracks per Zone} i2
{Alternate Tracks per Logical Unit} i2
{Sectors per Track} i2
{Data Bytes per Physical Sector} i2
{Interleave} i2
{Track Skew Factor} i2
{Cylinder Skew Factor} i2
{SSEC} t1
{HSEC} t1
{RMB} t1
{SURF} t1
{Reserved} *t4
}
# Medium types supported page:
0x0b {
{Reserved} *i1
{Reserved} *i1
{Medium type one supported} i1
{Medium type two supported} i1
{Medium type three supported} i1
{Medium type four supported} i1
}
# Notch page (0x0c)
# Read-Write Error Recovery Page
0x01 {
{AWRE (Auto Write Reallocation Enbld)} t1
{ARRE (Auto Read Reallocation Enbld)} t1
{TB (Transfer Block)} t1
{RC (Read Continuous)} t1
{EER (Enable Early Recovery)} t1
{PER (Post Error)} t1
{DTE (Disable Transfer on Error)} t1
{DCR (Disable Correction)} t1
{Read Retry Count} i1
{Correction Span} i1
{Head Offset Count} i1
{Data Strobe Offset Count} i1
{Reserved} *i1
{Write Retry Count} i1
{Reserved} *i1
{Recovery Time Limit} i2
}
# Rigid Disk Drive Geometry Page
0x04 {
{Number of Cylinders} i3
{Number of Heads} i1
{Starting Cylinder-Write Precompensation} i3
{Starting Cylinder-Reduced Write Current} i3
{Drive Step Rate} i2
{Landing Zone Cylinder} i3
{Reserved} *t6
{RPL} t2
{Rotational Offset} i1
{Reserved} *i1
{Medium Rotation Rate} i2
{Reserved} *i1
{Reserved} *i1
}
# Verify Error Recovery Page
0x07 {
{Reserved} *t4
{EER} t1
{PER} t1
{DTE} t1
{DCR} t1
{Verify Retry Count} i1
{Verify Correction Span} i1
{Reserved} *i1
{Reserved} *i1
{Reserved} *i1
{Reserved} *i1
{Reserved} *i1
{Verify Recovery Time Limit} i2
}
# CD-ROM Audio Control Parameters Page
0x0E {
{Reserved} *t5
{Immed} t1
{SOTC} t1
{Reserved} *t1
{Reserved} *i2
{APRVal} t1
{Reserved} *t3
{Format of LBAs / sec.} t4
{Logical Blocks per Second of Audio Playback} i2
{Reserved} *t4
{Output Port 0 Channel Selection} t4
{Output Port 0 Volume} i1
{Reserved} *t4
{Output Port 1 Channel Selection} t4
{Output Port 1 Volume} i1
{Reserved} *t4
{Output Port 2 Channel Selection} t4
{Output Port 2 Volume} i1
{Reserved} *t4
{Output Port 3 Channel Selection} t4
{Output Port 3 Volume} i1
}
0x10 {
{Reserved} *t1
{Change Active Partition} t1
{Change Active Format} t1
{Active Format} t5
{Active Partition} i1
{Write Buffer Full Ratio} i1
{Write Buffer Empty Ratio} i1
{Write Delay Time} i2
{Data Buffer Recovery} t1
{Block Identifiers Support} t1
{Report Setmarks} t1
{AAutomatic Velocity Control} t1
{Stop on Consecutive Filemarks} t2
{Recover Buffer Order} t1
{Report Early-Warning} t1
{Gap Size} i1
{EOD Defined} t3
{Enable EOD Generation} t1
{Synchronize at Early-Warning} t1
{Reserved} *t3
{Buffer Size at Early-Warning} i3
{Select Data Compression Algorithm} i1
{Reserved} *i1
}