# # Copyright 2007 Sun Microsystems, Inc. All rights reserved. # Use is subject to license terms. # # CDDL HEADER START # # The contents of this file are subject to the terms of the # Common Development and Distribution License (the "License"). # You may not use this file except in compliance with the License. # # You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE # or http://www.opensolaris.org/os/licensing. # See the License for the specific language governing permissions # and limitations under the License. # # When distributing Covered Code, include this CDDL HEADER in each # file and include the License file at usr/src/OPENSOLARIS.LICENSE. # If applicable, add the following below this CDDL HEADER, with the # fields enclosed by brackets "[]" replaced with your own identifying # information: Portions Copyright [yyyy] [name of copyright owner] # # CDDL HEADER END # #ident "%Z%%M% %I% %E% SMI" # # /etc/default/kbd # # kbd default settings processed via kbd(1). # # KEYBOARD_ABORT affects the default behavior of the keyboard abort # sequence, see kbd(1) for details. The default value is "enable". The # optional values are "disable" or "alternate". Any other value is ignored. # If you choose "alternate" it will affect the serial console drivers ONLY. # The keyboard BREAK (sequence and plug/unplug) won't be affected by this. # If "alternate" is in effect any protocol (PPP, SLIP... etc) should not be # run over the serial console port. # # KEYCLICK affects the default keyclick behavior. Possible values are # 'on' and 'off'. Any other value is ignored. The default behavior is # to leave the current keyclick setting unchanged. # # Uncomment the following line to disable keyboard or serial device # abort sequences: #KEYBOARD_ABORT=disable # Uncomment the following line to enable a non-BREAK alternate # serial input device abort sequence: #KEYBOARD_ABORT=alternate # Uncomment the following line to change the keyclick behavior: #KEYCLICK=off # Uncomment the following lines to set up autorepeat delay and rate, # units in milliseconds: #REPEAT_DELAY=500 #REPEAT_RATE=33 # Uncomment the following line to set up the keyboard layout. The # keyboard layouts supported can be listed by running 'kbd -s'. # The value will override the keyboard-layout value supplied in eeprom # if it exists in eeprom when system boots. #LAYOUT= # Uncomment the following line to set up the keyboard beeper # frequency. The valid frequency range is [0 - 32767], units in Hz #KBD_BEEPER_FREQ=2000 # Uncomment the following line to set up the console beeper # frequency. The valid frequency range is [0 - 32767], units in Hz #CONSOLE_BEEPER_FREQ=900