V7/usr/doc/troff/add

.nr i 1i
.de H
'sp |.5i-1
.tl 'May 15, 1977'''
'sp |1i
..
.de F
'bp
..
.wh 0 H
.wh -1i F
.de pp
.ft R
.sp
.ti 0
..
.de h
.sp
.ti0
\fB\\$1\fP
.br
..
.ce
.ftB
Summary of Changes to N/TROFF Since October 1976 Manual
.ft
.ta \niu
.in \niu
.h Options
.pp
-h	(Nroff only) Output tabs used during horizontal spacing
to speed output as well as reduce output byte count.
Device tab settings assumed to be every
8 nominal character widths.
The default settings of input (logical) tabs is also
initialized to every 8 nominal character widths.
.pp
-z	Efficiently suppresses formatted output.
Only message output will occur (from "tm"s and diagnostics).
.h "Old Requests"
.pp
\&.ad\ c	The adjustment type indicator "c" may now also be a number
previously obtained from the ".j" register (see below).
.pp
\&.so\ name	The contents of file "name" will be interpolated
at the point the "so" is encountered.
Previously, the interpolation was done upon return to the file-reading input level.
.h "New Request"
.pp
\&.ab\ text	\
Prints "text" on the message output and terminates
without further processing.
If "text" is missing, "User Abort." is printed.
Does not cause a break.
The output buffer is flushed.
.pp
\&.fz F N	\
forces f_ont "F" to be in siz_e N.
N may have the form N, +N, or -N.
For example,
     .fz 3 -2
.br
will cause an implicit \es-2 every time font 3 is entered,
and a corresponding \es+2 when it is left.
Special font characters occurring during the
reign of font F will have the same size modification.
If special characters are to be treated differently,
     .fz S F N
.br
may be used to specify the size treatment of special
characters during font F.
For example,
     .fz 3 -3
     .fz S 3 -0
.br
will cause automatic reduction of font 3 by 3 points
while the special characters would not be affected.
Any ``.fp'' request specifying a font on some position
must precede ``.fz'' requests relating to that position.
.h "New Predefined Number Registers."
.pp
\&.k	Read-only. Contains the horizontal size
of the text portion (without indent) of the current
partially collected output line, if any, in
the current environment.
.pp
\&.j	Read-only. A number representing the current adjustment mode and type.
Can be saved and later given to the "ad" request to restore a previous mode.
.pp
\&.P	Read-only.
1 if the current page is being printed,
and zero otherwise.
.pp
\&.L	Read-only.
Contains the current line-spacing parameter ("ls").
.pp
\&c.	General register access to the input line-number
in the current input file.
Contains the same value as the read-only ".c" register.