[COFF] VT100 TX but no RX?

[segaloco via COFF]

Drawing a major blank and can't figure this out.  I got a VT100 some time ago, fixed up several things, but am still struggling a bit.  Was wondering if someone on list could give me some advice.

Currently I've got the thing plugged into a little MAX232 adapter that level shifts from 5V to 3.3V, then into a USB TTL thing.  Sending characters from the VT100 is fine, I cat /dev/ttyUSB2 and every key I type on the VT100 shows up on my monitor.  However, any bytes I write back out to /dev/ttyUSB2 don't seem to go anywhere.  There shouldn't be hardware flow control involved, I can use the same adaptors with 3.3V devices in both directions just with TX/RX/GND, its just if the VT100 is on the other end, characters only seem to go one way.  If I launch getty against the device it seems to timeout.  For the record local mode works, so the general character generator/display are functional, I'm just not getting printing of stuff coming on the RX line.

The odd thing is communication in one direction is totally fine, I get the expected bytes on my computer, I just can't seem to get the VT100 to accept anything back.  I've messed with the auto XOFF/XON settings to no avail, and have tried both low and high baud rates.  Consistently everything I type on the VT100 shows up on the computer but neither echoes back nor anything new coming from the computer.  Am I missing something painfully obvious or perhaps am I looking at maybe having a bad receiver circuit?  I might just pony up and order another basic video board, the traces are pretty squiggly from expansion over the years...

- Matt G.