9-track tape interfaces
David C. Jenner
djenner at halcyon.com
Tue Dec 8 06:12:20 AEST 1998
Tim Shoppa wrote:
>
> A lot, so I snipped it out!
>
As long as this thread is red hot, how about these questions:
I have an M4 Data 9914 tape drive with Pertec and SCSI interfaces.
It will do 800, 1600, 6250. I want to set up and run 2.11BSD on a
Q-Bus system.
1) I'd rather not spend a lot to get a SCSI interface. I now have
Emulex TC02 and Dilog DQ130 Q-Bus controllers. Is there
any way these controllers are going to enable 6250 BPI?
2) Is there another Q-Bus, Pertec controller that will do 6250?
3) If I had a Q-Bus SCSI controller, would it enable 6250?
4) (Already asked in thread) Supposing I get the hardware to work
at 6250, will 2.11BSD handle it?
Thanks,
Dave
Received: (from major at localhost)
by minnie.cs.adfa.edu.au (8.9.1/8.9.1) id HAA15025
for pups-liszt; Tue, 8 Dec 1998 07:27:55 +1100 (EST)
More information about the TUHS
mailing list