Although the _kernel_ source for V1 is available: https://minnie.tuhs.org//cgi-bin/utree.pl?file=V1 most of the rest is missing; only 'init' and 'sh' are available. So one would have to write almost _everything_ else. Some commands are available in PDP-11 assembler in later versions, and might be movable without _too_ much work - but one would have to start with the assembler itself, which is luckily in assembler. If I were trying to run 'UNIX' on an -11/20, I think the only reasonable choice would be MINI-UNIX: https://gunkies.org/wiki/MINI-UNIX It's basically V6 UNIX with all use of the PDP-11 memory management removed. The advantage of going MINI-UNIX is that almost all V6 source (applications, drivers, etc) will run on it 'as is'. It does need ~56KB of main memory. If you don't have that much on the -11/20, LSX (links in the above) would be an option; it's very similar to MINI-UNIX, but is trimmed down some, to allow its use on systems with less main memory. I'm not sure if MINI-UNIX has been run on the -11/20, but it _should_ run there; it runs on the -11/05, and the only differences between the /20 and the /05 are that the /20 does not have the RTT instruction (and I just checked, and MINI-UNIX doesn't use RTT), and SWAB doesn't clear the V condition code bit. (There are other minor differences, such as OP Rn, (Rn)+ are different on the -11/20, but that shouldn't be an issue.) Step 1 would be to get MINI-UNIX running on an -11/20 under a simulator; links in the above to get you there. Noel