[TUHS] Installing SysIII on simh?

I am having difficulty installing SysIII on simh. I have attached my simh pdp11 ini file (sys3.simh.bootstrap) and the Perl script used to create the install tape (mksys3tap.pl). Everything seems to go fine while installing the miniroot, but when I try to boot from the "installed" system I don't get very far. Below is a transcript. Any ideas? Andru $ pdp11 sys3.simh.bootstrap PDP-11 simulator V2.10-3 RL: creating new file Create bad block table on last track? [N] UNIX tape boot loader UNIX -- Initial Load: Tape-to-Disk The type of disk drive on which the Root file system will reside, as well as the type of tape drive that will be used for Tape 1 must be specified below. Answer the questions with a 'y' or 'n' followed by a carriage return or line feed. There is no type-ahead -- wait for the question to complete. The character '@' will kill the entire line, while the character '#' will erase the last character typed. RP03 at address 176710?: n RP04/5/6 at address 176700?: n RL01 at address 174400?: y Drive number (0-3)?: 0 Disk drive 0 selected. Mount a formatted pack on drive 0. Ready?: y TU10/TM11 at address 172520?: y Drive number (0-7)?: 0 Tape drive 0 selected. The tape on drive 0 will be read from the current position at 800bpi, 5120 characters (10 blocks) per record, and written onto the pack on drive 0 starting at block 0. Ready?: y Size of filesystem to be copied is 6000 blocks. What is the pack volume label? (e.g. p0001): The pack will be labelled p0001. The boot block for your type of disk drive will now be installed. The file system copy is now complete. To boot the basic unix for your disk and tape drives as indicated above, mount this pack on drive 0 and read in the boot block (block 0) using whatever means you have available; see romboot(8), 70boot(8). Then boot the program unixrltm using diskboot(8). Normally: #0=unixrltm The system will initially come up single-user; see init(8). If you have an upper case only console terminal, you must execute: stty lcase; see stty(1). After UNIX is up, link the file unixrltm to unix using ln(1). # ln /unixrltm /unix Set the date(1). Good Luck! The tape will now be rewound. HALT instruction, PC: 002460 (BR 2456) sim> boot rl0 #0=unixrltm ka6 = 1512 aps = 141774 pc = 1476 ps = 30010 trap type 0 ka6 = 1512 aps = 141666 pc = 113444 ps = 30300 trap type 0 panic: trap