Looking thru the code for setjmp/longjmp
and have a question. Longjmp seems to make an attempt at restoring
register two through four, but setjmp doesn't save them. Where do
these register get saved from?
setjmp and longjmp are intimately familiar with the way in which
the standard stack frame for C functions is laid out
The stack frame itself is maintained by the functions csv and cret
which are defined in /usr/src/libc/crt/csv.s
The C compiler generates a call to csv at the start of each function:
jsr r5, csv
which has the net effect of saving the current value of r5 on the stack,
setting r5 to point to the saved r5, and saving r4, r3 and r2
and at the end of each function it generates:
which restores the values of r2 - r5 and returns to the function's caller.
Thus r5 is used as a frame pointer.
All that setjmp saves are the values of r5, sp and the return address.
When longjmp is called it walks back up the chain of frame pointers
pointed to by r5 until it gets to the frame immediately below the
one for the context it wants to return to. It then patches the return
address in that frame to be the return address saved by setjmp and
uses cret to restore everything (almost) as if setjmp had just returned.
Note that this means that r4, r3 and r2 get restored to the values
that they had at the time that the next stack frame was established
(ie when the "next" function down was called from the original context)
and that these are not necessarily the values that they had at the
moment when the original call to setjnp returned. Hence the various
caveats about not relying on the value of any register variables
after returning via longjmp.