[pups] 2.11BSD networking on simh

I have gotten 2.11 installed on simh, I have it recognizing the simulated ethernet card, and everything appears correct except the packets just aren't getting in and out. The simh documentation says that the DELQA card is better than the DEQNA, but I was unable to get the DELQA (qt) driver to recognize the card. When I compiled the kernel to use the DEQNA (qe) driver and set the card up in DEQNA mode, the emulated card and its ethernet address were correctly detected. I have configured 2.11BSD with: A valid IP address on the network the host is on. The same netmask, broadcast, and gateway as the host. I am running the emulator as root. I have attached the DEQNA to the appropriate ethernet card. I can see the ethernet card go into promiscuous mode when I start the emulator. I have tested it with SANITY=ON and SANITY=OFF. The docs say you won't be able to talk between the host and the emulated machine, so my test for each configuration has been pinging the gateway, which I know responds to pings since I can ping it from the host. I have been over both the 2.11BSD docs and the simh docs several times and as far as I can tell I am doing everything correctly. I would appreciate any hints that any of you can offer. Thanks, Andru Quote Of The Moment: Appel's method avoids making a large number of small trampoline bounces by occasionally jumping off the Empire State Building. -- Henry G. Baker, "Cheney on the M.T.A."